التفاصيل البيبلوغرافية
| العنوان: |
The Effect of Knife Wear and Sharpening Mode on Chipper Productivity and Delays. |
| المؤلفون: |
Mihelič, Matevž, Vusić, Dinko, Ursić, Branko, Zadro, Antonio, Spinelli, Raffaele |
| المصدر: |
Forests (19994907); Jul2024, Vol. 15 Issue 7, p1101, 11p |
| مصطلحات موضوعية: |
CHIPPERS (Landscape equipment), ANALYSIS of variance, RAW materials, KNIVES, WOOD chips, ROADSIDE improvement |
| مستخلص: |
The production of wood chips can be achieved using different types of wood chippers whose productivity can be influenced by many factors including proper knife management. Research was conducted to determine the productivity of the new Diamant chipper in chipping air-dried tops stacked at a roadside landing and to compare the efficiency of dry sharpening and wet sharpening in restoring chipper productivity, the time required by dry sharpening with that of knife replacement, and the cost of dry sharpening to knife change in real-life conditions. To clearly define the influence of knife management, a model of the effect of knife wear on chipper productivity was produced. Analysis of variance was used to check the significance of any differences in chipping and total time consumption per cycle. Multiple regression was used to express the relationship between chipping time consumption per cycle and the cumulated mass processed by a set of knives—the latter taken as an indicator of knife wear. The study lasted 10 full workdays, included a total of 136 truckloads or 3560 t of fresh wood chips (or green tons = gt), and resulted in the average productivity of 59.0 gt per productive chipping hour (excluding all delays) or 39.4 gt per machine scheduled hour (including all delays). Delays represented 37% of total worksite time. Knife management (dry sharpening or change) accounted for 30% of the total delay time due to raw material contamination. Dry sharpening took 30% less time than a full knife change. As wear accumulated and knives lost their edge, the chipping time per cycle increased from 25 in the first cycle (full truck load) to 38 min in the third cycle. The presented study offers robust productivity figures, together with a reliable estimate of the productivity losses caused by knife wear, and could help improve knife management in order to increase chipper productivity as well as reduce unnecessary delays. [ABSTRACT FROM AUTHOR] |
|
Copyright of Forests (19994907) is the property of MDPI and its content may not be copied or emailed to multiple sites or posted to a listserv without the copyright holder's express written permission. However, users may print, download, or email articles for individual use. This abstract may be abridged. No warranty is given about the accuracy of the copy. Users should refer to the original published version of the material for the full abstract. (Copyright applies to all Abstracts.) |
| قاعدة البيانات: |
Complementary Index |
Full Text Finder