An Experimental Study of Heat Transfer Coefficient in a Bubble Flow throughout an Annulus Pipe Heated at Inner Wall

التفاصيل البيبلوغرافية
العنوان: An Experimental Study of Heat Transfer Coefficient in a Bubble Flow throughout an Annulus Pipe Heated at Inner Wall
المؤلفون: Sarjito, Putro, Sartono, Nugraha, Nurmuntaha Agung
المصدر: Applied Mechanics and Materials; October 2014, Vol. 660 Issue: 1 p654-658, 5p
مستخلص: The aim of the research work describe in this paper is to investigate correlation of water, air massflow rate and calor fluks to heat transfer coefficient. The investigation was carried out toward a pipe section test developed from acrylic with diameter of 60 mm and 210 mm length, therefore, the buble can be easier to shoot. A concurrent water were flowed upward and air was injected from the bottom. The wall of the heater was heated using two thermocouple installed at the outer surfece of the heater. The fluid flow was measured using thermocouple installed along the annulus pipe. A heater with transparent tube diameter of 50 mm and 1800 mm length was also installed, and supplied with 1000 Watt electric power. Result of the experiment showed that heat transfer coefficient incresed along with the air massflow rate increased, and its decreased with the increasing of water mass flow rate. The maximum heat transfer coefficient of 4340,602 W/m2 °C at electric fluck calor of 29582,448 W/m2 was echieved on water volume flow rate of 3 lpm and 9 lpm of air volume rate.
قاعدة البيانات: Supplemental Index
الوصف
تدمد:16609336
16627482
DOI:10.4028/www.scientific.net/AMM.660.654