The processes which are currently studied in the fabrication of B-doped ultra shallow junctions (USJ) usually involve a preamorphization step to reduce B channelling effect during implantation and to improve B electrical activation. At this stage a high amount of Si interstitial atoms (Is), which dramatically increases the B diffusivity, is introduced. The introduction of voids in Si is a promising tool to control B transient enhanced diffusion (TED), because of their ability to capture Is. In this work the efficiency of a cavity band to reduce B TED is checked in silicon interstitial supersaturation conditions, obtained by high dose Si implantation. He is implanted either at 10 keV or at 50 keV with a fluence of 5 × 1016 cm−2. Conventional techniques to introduce and activate the B (conventional ion implantation and rapid thermal annealing (RTA)) are applied in order to have a better control of the technological process to focus on the benefit of the cavity layer. The samples were characterized by cross section transmission electron microscopy (XTEM), secondary ion mass spectroscopy (SIMS) and Hall Effect (HE). The latter shows that good activation of the B is achieved only after 1000 °C RTA, though a 900 °C RTA is sufficient for implantation-damage recovery, as it is confirmed by XTEM observations. B SIMS profiles show that the band of cavities plays its best effect in reducing B TED when it is located near the surface.
