Preparation and Characterization of Poly(butylene succinate)/Polylactide Blends for Fused Deposition Modeling 3D Printing
| العنوان: | Preparation and Characterization of Poly(butylene succinate)/Polylactide Blends for Fused Deposition Modeling 3D Printing |
|---|---|
| المؤلفون: | Baohua Guo, Qing Ou-Yang, Jun Xu |
| المصدر: | ACS Omega, Vol 3, Iss 10, Pp 14309-14317 (2018) ACS Omega |
| بيانات النشر: | American Chemical Society (ACS), 2018. |
| سنة النشر: | 2018 |
| مصطلحات موضوعية: | chemistry.chemical_classification, 0209 industrial biotechnology, Toughness, Materials science, Fused deposition modeling, Bond strength, General Chemical Engineering, 02 engineering and technology, General Chemistry, Polymer, 021001 nanoscience & nanotechnology, Gloss (optics), Article, Polybutylene succinate, law.invention, lcsh:Chemistry, Crystallinity, 020901 industrial engineering & automation, lcsh:QD1-999, chemistry, law, Ultimate tensile strength, Composite material, 0210 nano-technology |
| الوصف: | To obtain a new type of biodegradable material with high toughness and strength used for fused deposition modeling (FDM) printing, a series of poly(butylene succinate) (PBS)-based polymer materials was prepared via blending with polylactide (PLA). The rheological, thermal, and mechanical properties as well as FDM printing performances of the blends, such as distortion, cross section, and the interlayer bond strength, were characterized. The results show that with increasing PLA content, the blends possess higher melt viscosity, larger tensile strength, and modulus, which are more suitable for FDM printing. Especially, when the content of PLA is more than 40%, distortion due to residual stress caused by volume shrinkage disappears during the printing process and thus products with good dimensional accuracy and pearl-like gloss are obtained. The results demonstrate that the blend compositions with moderate viscosity, low degree of crystallinity, and high modulus are more suitable for FDM printing. Compared with the low elongation upon breaking of commercially FDM-printed material, the PBS/PLA blend materials exhibit a typical ductile behavior with elongation of 90-300%. Therefore, besides biodegradability, the PBS/PLA blends present excellent mechanical properties and suitability as materials for FDM printing. In addition, our study is expected to provide methods for valuating the suitability of whether a thermoplastic polymer material is suitable for FDM printing or not. |
| تدمد: | 2470-1343 |
| URL الوصول: | https://explore.openaire.eu/search/publication?articleId=doi_dedup___::2e749749cbff0c7dadc3e145db67cd42 https://doi.org/10.1021/acsomega.8b02549 |
| حقوق: | OPEN |
| رقم الأكسشن: | edsair.doi.dedup.....2e749749cbff0c7dadc3e145db67cd42 |
| قاعدة البيانات: | OpenAIRE |
Find this issue from the American Chemical Society | تدمد: | 24701343 |
|---|